Jump to content
  • 0

Dual band antenna in fender mount


fremont

Question

7 answers to this question

Recommended Posts

  • 0

Members have had ok results with fender mounts (Comet RS720) on jeeps. Make sure you get a water proof NMO mount/cable that has the sealed bottom, or corrosion will ruin your antenna mount within a year. I would suggest spending just a few more bucks for a Larsen NMO150/450/758 antenna, its great on 2M, 70CM and is wide band enough for GMRS. Below are my results of this antenna with a magmount on the roof of my car:

 

50040161106_f8f38d7f10_c.jpgVSWR updated by tweiss3, on Flickr

Link to comment
Share on other sites

  • 0

I assume you mean a mount between the hood and the fender. I use a 1/4 wave antenna with NMO mount for my 2M amateur radio. SWR is 1:1.2 in the middle of the band. Great reception and I can hit repeaters 25+ miles away on low power. Fender mounts are great, unless you’re in a Jeep for some reason. Remember, police cars and ambulances have used them for decades. You should be good.

Link to comment
Share on other sites

  • 0

Also, look at the thread here, it looks like a knock off of the Larsen Antenna that Lscott reviewed here: https://forums.mygmrs.com/topic/1924-larsen-pulse-270-sh/?do=findComment&comment=17016

 

I reviewed it, either case the Larsen NMO 2/70b is a genuine from Gigaparts. It was bent up in transit and still has a kink in it. Beats me why Gigaparts took a 3 foot long whip and jammed it inside a 6"x6" box.

 

Keep in mind the numbers are from the antenna not being tuned. I simply mounted the whip to the coil/base and took measurements.  I also noted that there was a paint drip on the coil, not sure if that is affecting the numbers. Probably going to contact Larsen to see if I can get a new whip. The 

 

I will be getting clippers out to tune it bit better in the future. I don't transmit much on the GMRS/FRS frequency so the numbers didn't matter.They were acceptable for me as is. Since the signal reports are great. I have to really concentrate on rebuilding the center console, so I can get the FTM400 and android radio (APRS display) in.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Guidelines.