Jump to content

Motorola UHF T1504A Duplexer


batt63

Recommended Posts

  • 2 weeks later...
  • 3 months later...

I seem to recall that T1504 was a four bandpass/reject cavity duplex filter. It may have been sold as a kit of parts. But in any event depending upon the frequency band you got a set of critical length interconnect cables and a "T" connector. The duplexer is band pass with reject notch filters. The band pass is wider than the reject notch so after first tuning band pass, then tuning reject, you could fine tune the reject with the pass knobs.  That is how I did it and they worked well. The trick was that the screws on the slotted reject loop had to be almost tight so they made reliable connection and then I would "rap" the screws one direction or the other in the slot to tune the notch. A couple Excelite nut drivers were the ideal tools to move the knurled nut. Use one as a "hammer" and the other as a "chisel" and tap their plastic heads together to move the nut just enough. Then hand tighten,

Link to comment
Share on other sites

  • 1 month later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Guidelines.