[UV9G REPTR PROGRAM]

28 minutes ago, WRUU653 said:

Okay so I read your post again and 32 is 462.575. If you are trying to put in 462.675 it will be on your repeater channel/diy in locations 28 or 36 and the offset will already be in there. It is easier to see and program in chirp. Hope this helps. 

Ok I will try 28 or 36 see if thag works thanks

[UV9G REPTR PROGRAM]

I did not know what repeater channel was the one I needed so I just made one on the diy 32 channel 

 

[UV9G REPTR PROGRAM]

1 minute ago, WRUU653 said:

 

where are you trying to program this? Are you in channel mode? If so what channel? The offset should already be set in channel mode on the repeater channels. You wont be able to transmit in frequency mode. 

I set it to a diy channel 32 program in frequency mode then switched to channel mode

[Input Tone? Output Tone? Am confused.]

On 8/1/2023 at 11:09 PM, ClockworkComic said:

So I'm trying to set up a Wouxun KG-805G radio to use a repeater.  
Specifically, it's @Cactusboy19 's lovely looking repeater.  

The repeater lists Input Tone, and Output Tone.  I've tried the manual, and NotaRubicon's lovely videos, but I am still not sure I'm setting this up right. 

Is it that "Input Tone" = T-DCS  and "Output Tone" = R-DCS?
 

or am I way off track? 

Try ctss some are ctss aome are dcs 

[Baofeng UV-9G won't transmit on freqs entered from keypad even when they are GMRS freqs.]

On 2/25/2023 at 6:18 PM, WRWF246 said:

It appears my 9G will transmit properly when using frequencies that were already entered into radio or entered using the software.

However, when I enter a valid GMRS frequency in frequency mode from the radio keypad the radio will not transmit on that freq.

Anyone else seen this problem.

Thanks, John

I am having the same problem with Is repeaters programmed by hand I just posted a question about that 

[UV9G REPTR PROGRAM]

Trying to program a reportepeater manually 462.675 +5 with tone 141.3 

I am put in 462.675 offset 005.000 shift + save then put in 467.675 and save nothing happens but WHT I program with chirp 462.575 it works I think I ha e not heard the Repeater give me any thing back what am I doing wrong and if any one is near this one we can try to talk and see if it is working just let me k ow the tone and I will use chirp to program then we can test thanks