WSES676

Thanks Steve..... This is the configuration I used based on your reply. Hope i did it right. Still not hitting the repeater but if the settings are correct, then I'm satisfied I'm not hitting for other reasons. I just think I should easily hit it from my location as I'm hitting repeaters farther away (I know, there are other factors). Please see below:

Thanks for the reply, but the DTCS tones in chirp don't match the websites tones for that repeater. Can't be digital, right? I tried cross tone mode "tone-tone". Still not opening the repeater but I'm close enough it should. See below. I know it's possible I'm just not hitting the repeater but I'm easily hitting much further repeaters.

I'm trying to program Chirp with a GMRS repeater that has dual tones. Not sure if I'm doing it right. In this example, the Repeater is in Bonney Lake, WA: Is Tone mode TSQL? Where do I put the dual tones? Input tone is 218.1mhz and output tone is 114.8mhz...... The only columns I can choose for those numbers is: Tone Mode, Tone, Tone Squelch, DTCS, RX DTCS, DTCS Polarity, Cross Mode and Duplex. Please help me with the programming of the two tones and the proper modes. Thanks WSES676