dsm600rr

I am not sure, I didn't even know this was a thing until now! haha

After messing around with the Channel Wizard everything you said makes perfect sense and I had the same results.

Agreed - after messing around with it, I like it. I do want to use my PC to add all the local frequencies and set up some scan groups. Would you use the Wouxun software or Chirp? And what cable? I see these two options: Wouxun USB Programming Cable (PCO-001 / PCO-009) XLT Painless Programming Cable I appreciate all the replies.

Hello all, Looking to maybe upgrade the Antenna on my Wouxun KG-935G Plus. From researching, it seems the stock antenna performs quite well, so curious if anything would help get a bit more performance? I was looking at: - Nagoya NA-771G - Smiley 5/8 Slim Duck 465 - Smiley SUPER STICK IV 465 MHZ Very new - so open to other suggestions. Lastly, looking for an Antenna Setup to run with a Wouxun KG-1000G Plus (I haven't ordered this yet). I am open to drill or magnetic. These would go in a few Transit Connect Fleet Vans - looking for the best mounting solutions/suggestions that will work best together. Thanks!

Shocker - anyway I appreciate the info. I believe all is working as intended - plan to verify on the other radio once it arrives - and then to find a Mobile Setup "thinking a: Wouxun KG-1000G Plus".

Always the Cali guys - I swear.

I am not in range of the repeater from my home, only office. I would assume so, as switching to frequency mode shows the correct frequency. Sounds like the Channel Wizard is to get the channel built and then that's it - which is fine I just wanted to make sure its behaving as it should. I do have another KG-935G+ on the way with a programming cable - however it has been quite simple from the radio as well.

Hello All, Very new both here and with GMRS - and I seem to be having an issue with the Channel Wizard when adding a repeater. Repeater is: 462.725 MHz with a 67.0Hz Input tone. So I go thru the channel wizard and input this info and save. Everything looks good until I power cycle the radio. If I go back into the Chanel Wizard, it now shows the Rx-Freq = 462.55000 however If I exit out of this and use "mode" to get the selected repeater to show its frequency, it is showing the correct 462.725 MHz. Why does the channel wizard not reflect this after a power cycle? The input tone and everything else still looks good. Here is a Video