I’m hoping someone with Kenwood expertise can chime in here and help. I was updating the radio programming (adding some repeaters, turned off the Power On tone, nothing crazy) and with Unit 1, everything went well.
I wrote the update to the second radio, but afterward the green light remains lit on each repeater channel regardless of whether there’s a signal or not. Additionally, it turned off the squelch on the 22 simplex channels that I have programmed on Group 1, but the programmed squelch level was not changed. Almost like the monitor function was turned on (it doesn’t appear to be).
I figure I must have bumped something in the programming software between radios, but I cannot determine what. Any help or guidance is appreciated!
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
WSAR579
I’m hoping someone with Kenwood expertise can chime in here and help. I was updating the radio programming (adding some repeaters, turned off the Power On tone, nothing crazy) and with Unit 1, everything went well.
I wrote the update to the second radio, but afterward the green light remains lit on each repeater channel regardless of whether there’s a signal or not. Additionally, it turned off the squelch on the 22 simplex channels that I have programmed on Group 1, but the programmed squelch level was not changed. Almost like the monitor function was turned on (it doesn’t appear to be).
I figure I must have bumped something in the programming software between radios, but I cannot determine what. Any help or guidance is appreciated!
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.