WSHG909

Yes. And searched online for a solution.

I've searched for a solution and tried several things, but cannot figure out how to to this: Radio is a DB40-G When scanning through channels and I hear someone talking, I want to stop the scan and stay on that channel even if there is a break in the transmission. But the radio resumes scanning after a few seconds when there is a break. I've tried to hit the scan button, but it defaults back to the last channel I was on before starting to scan. For instance, if I was on Channel 1 when I started scanning, and try to stop scanning to listen to channel 5, when I hit SCAN, it goes back to Channel 1. I've tried the PTT button and it pauses, but then resumes scanning. I've tried the CAN button and nothing happens And lastly, the Mode button - I don't think that did anything. Any advice on how to do this?

Thanks for your input. Hoping someone can provide something a little more useful in answering my question.

Hoping for some assistance in programming my GM30 Plus... I connect to the computer. Radio is ON. When I click "Read radio" I get a message that says "Failure". I'm using the correct Comport. If I try another Comport I get something in Chinese that I assume means Failure. Connection between radio and programming cable is good (as far as I can tell). Radio Info: Radio: 100 Firmware: Ver 0.06 Hardware: Ver 1.30 Not sure if there is some update to radio that might help? Thanks to anyone who might have some solutions!