w3ldr

Actually I worked through chirp and got the repeater to work however when I try to transmit from the tx repeater radio via the mic all it does is break the squelch on the radios I am transmitting to. Perhaps a bad mic it is a aftermarket motorola mic maybe thats the issue. But I know the repeater it transmitting as the maxtrac has 6 channels if we use the programmed hand helds and i change the tx radio channel we no longer can hear plus the busy and tx lights light up on both repeater tx rx radios when we are testing, Just would be nice to grab the TX Repeater radio mic and if I am at the base location....

Well image did not uplead here a link to the pic http://i989.photobucket.com/albums/af20/WestTexasFishingAdventures/Screen%20Shot%202015-07-19%20at%2010.30.39%20PM_zps3brfltcl.png http://i989.photobucket.com/albums/af20/WestTexasFishingAdventures/Screen%20Shot%202015-07-19%20at%2010.30.39%20PM_zps3brfltcl.png

More less I need to figure out how to program the radios for a gmrs repeater I am setting up I have a GMRS Repeater setup I purchased for my family for camping ect over a year ago just getting to set it up. Here is what I have using 2 Motorola MaxTrac 300 Radios that have been configured for repeater use and a duplexer from china tuned to the corresponding frequencies. 462.600 TX Radio hooked to Low side of duplexer 467.600 RX Radio hooked to high side of duplexer Antenna out on Duplexer to Antenna Tuned to GMRS Commercial frequencies by EdFong at 30ft in the air. the radios were both programmed with DPL 125 Here is the issue I never programmed a radio to use dpl I am using chorp to program so baofengs and this is what i have so far which does not work. I assume dtcs is dpl