KG-1000G plus VFO tuning

[LeoG]

So far I have been able to figure out a way to change frequencies to the VFO other than using the knob or up/down arrows which is painfully slow.  With the XS20G+ you just use the keypad on the mic to enter in whatever frequency you want.  So far the only way I can see to program frequencies is to use the CPS and program it with your computer.

Am I missing some trick?

[OffRoaderX]

23 minutes ago, LeoG said:

Am I missing some trick?

No, it's not a trick.  According to page 40 of the user manual, after switching to VFO mode by pressing the 6/Mode button, then press the 2/Mhz button to direct-enter your frequency.

...and, i just confirmed this works with the KG-1000G+ in my office right next to me... I was going to try it on my Bathroom KG-1000G+, but that's all the way down the hall.

[LeoG]

OK, I'll give that a shot.  Glad you didn't have to walk all that way Randy

 

And there it is.

Hard to believe after pressing those buttons randomly that it never showed itself.  So there is a trick.

[LeoG]

Confirmed, it works.  Thanks.

[Socalgmrs]

AMAZING!!!! What a very small amount of literacy does.   Manuals come with radios for a reason.  They are also available on the internet webby thingy.  

[LeoG]

I looked.  Apparently I scanned over it.  I looked on page 39 and didn't find what I needed.

 

Stop being an arrogant azz.

[OffRoaderX]

23 minutes ago, LeoG said:

Stop being an arrogant azz.

It's pronounced: reet-hard ..

[LeoG]

You pronounce it your way, I'll pronounce it mine.