Radioddity GM-30 Programming Software - Cannot change incorrect repeater transmit values for DIY channels

[WRUP693]

Recently purchased Radioddity GM-30
Firmware V06.03.009
Radioddity GM-30 GMRS Radio Program Software SAIN 3 LLC Version 1.05

The programming software allows modification to white cells. The gray cells are write protected. It is not possible to change ANY transmission frequency.

Channels DIY-4, DIY-12 and DIY-20 have the correct receive / transmit values for 462.6250 / 467.6250 repeaters.
Channels DIY-8, DIY-16 and DIY-24 have the correct receive / transmit values for 462.7250 / 467.7250 repeaters.
All other DIY channels have incorrect transmit frequencies which cannot be modified with this programming software.

The GM-30 cannot be programmed with Chirp.

[SteveShannon]

13 minutes ago, WRUP693 said:

Recently purchased Radioddity GM-30
Firmware V06.03.009
Radioddity GM-30 GMRS Radio Program Software SAIN 3 LLC Version 0.05

The programming software allows modification to white cells. The gray cells are write protected. It is not possible to change ANY tranmission frequency.

Channels DIY-4, DIY-12 and DIY-20 have the correct receive / transmit values for 462.6250 / 467.6250 repeaters.
Channels DIY-8, DIY-16 and DIY-24 have the correct receive / transmit values for 462.7250 / 467.7250 repeaters.
All other DIY channels have incorrect transmit frequencies which cannot be modified with this programming software.

The GM-30 cannot be programmed with Chirp.

I think we’ve heard of this problem before.  I don’t know what the resolution was, if there was one.

[axorlov]

Modify the RX frequency? To make the pair valid. For example, set DIY-23 RX to 467.725.

[WRUP693]

Unfortunately, there isn't any 467.6000 value in any DIY channel. 3 repeaters in my county are 462.6000 / 467.6000. I can program 1 of them in RPT-3. Not a useful radio where I live.

[WRUP693]

DIY Channel Cleanup

Remove DIY channels with 467.52500 in the TX Freq column. GMRS repeaters do not transmit on this frequency.

Modify the DIY channels with the mis-matched RX / TX pair by changing the RX value.

[WROA675]

On 4/20/2023 at 8:51 PM, WRUP693 said:

The GM-30 cannot be programmed with Chirp.

Third-party traffic/relay with possible solution: If you're not using the latest programming software, version 2.06 you may download it from Radioddity. Hope that helps.

[WRUP693]

Thanks. The 2.06 version has the DIY columns with the correct frequencies.