WSAP738

This is really helpful- thank you! If I were in the PNW, I'd be buying you drinks!

ok-thank you! I connected to the open repeater, which is a nice victory. No luck on the closed repeater yet, though.

Hi- yes, the Tx & Rx tones are different. They sent them to me when I joined the club. I will try again with tone mode. But where do I enter the two different PL tones in chirp? I might be too far away as I'm about 40 miles from the repeater (which states a 100 mile range btw). Hopefully not. Thanks again for your help!

I'm about 30 miles from the repeater, so that may be an issue. I did speak to someone, and they gave me the setup steps that I outlined above. Your club sounds great, btw. Too bad I'm on the east coast! To hear via simplex, do I just enter the frequency? Thanks, Gabe

Hi- I put the repeaters on channels 53, 54, and 55, as shown below. The last repeater on Ch 56 is an open repeater Thanks, Gabe

Hi, I am new to GMRS and am trying to connect UV-5G Plus with repeaters in the Tri-state area. I joined a repeater club to access a large repeater in my area, and I am trying to program everything via Chirp. Below is what I have entered: Frequency I set the tone mode to "cross," tone-tone, with the PL tones entered in the "Tone" and "Tone Squelch" columns. +5 offset FM power = high. These are three linked repeaters. I am not getting any sound or contacts back when I transmit. What am I doing wrong? Thanks! Gabe