fremont Posted July 22, 2020 Report Share Posted July 22, 2020 How much cable did I waste adjusting the two blades to cut at the proper depth? Too much to note. That was an hour I'll never get back. Quote Link to comment Share on other sites More sharing options...
0 marcspaz Posted July 22, 2020 Report Share Posted July 22, 2020 That stinks... I have been making cables for 35 years. Always do them by hand with a straight razor. Make sure its sharp so you need minimal pressure and you will never cut the shield or center lead by mistake. The only time I use a tool is when I strip very thin cables that I can hold with needle nose pliers and wire strippers like the one in the picture. And I don't bother setting the guide stop. Again, just make sure they are sharp and use light pressure to squeeze and twist and you are good to go. Quote Link to comment Share on other sites More sharing options...
Question
fremont
How much cable did I waste adjusting the two blades to cut at the proper depth? Too much to note. That was an hour I'll never get back.
Link to comment
Share on other sites
1 answer to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.