Jump to content
  • 0

Repeater Programming on a UV-5G



Newbie here, have a UV-5R GMRS Baofeng, preprogrammed with repeaters. Chirp software does not contain this radio yet, it labels the radio a UV-5G even though on the face it says it is a UV-5R with GMRS label behind the battery. I tried to program the DCS receive/transmit tones into the pre-programmed repeater channel along with offset and it does not save in channel mode. So I tried to program the actual repeater by the frequency. On the receive frequency I input the DCS tone and offset and save to a new channel, then program the repeaters transmit frequency with the transmit DCS tone and save to the same channel. I can listen to everything on the channels I saved for the repeater and I can use the PTT button to see the offset occur but I cannot transmit. Help?

Link to comment
Share on other sites

3 answers to this question

Recommended Posts

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use and Guidelines.