I was one of the "early adopters" of the KG1000 and it has been my main radio in my Jeep for about 3 years now. The KG1000G has always had some issues (had to replace one radio early on because of mic gain issues and static/popcorn that would not go away). But the issue have started to become obvious defects and I'm hoping that perhaps a firmware update or something like that might make the radio function properly. The latest two issues are as follows:
1. Normally I run with Channel 15 (with tones) on the A side of the radio and Channel 17 with tones on the B Side (our club uses these are our A and B channels). While on GMRS channel 15 (462.550) or 17 (462.600) on the A-side of the radio (these are the only two tested), there is constant bleed-over from FRS channel 1 (462.5625). Every time some kid on a walkie talkie starts sqwawking (or there is a blast of interference on that frequency like in my video as I was sitting in an In-n-Out drive-through), it breaks the squelch on my radio and stomps over whatever legitimate traffic is on my selected frequency. The display will even briefly indicate "GMRS-01" while the interference is happening. This does NOT happen on the B side of the radio. I have tried adjusting the squelch up and down and it makes no difference. This makes the radio nearly unusable and I have to shut off the A side of the radio and only use the B side.
2. On both the A and B sides of the radio, regardless of what frequency or channel I am using, ALL broadcasts received will "clip" a few seconds into the transmission (drop out so I cannot hear for about 1 to 2 seconds). If I am running an HT right next to the KG1000-G it will NOT exhibit this problem, so I know for certain that the issue is the KG1000 itself. I can reproduce this issue at will by having another radio make a broadcast longer than about 10-15 seconds. I have also tested with my DB20-G and it does not have this problem while running trails with my group.
Do either of these issues sound familiar to anyone, and if so is there a firmware update to address the issue? I don't know what the warranty period is on this radio, but it looks like I'm coming up on the 3 year mark of owning it. (honestly based on my experience with this radio I'm not sure I can continue to recommend it!). Maybe I just got a buggy one but its been problematic throughout its lifetime with me...
Buytwowayradio has always provided great support - I hope there is an easy fix to this issue so I don't have to replace the KG1000 in my main vehicle with my cheapie backup radio (which never has problems!)
You can post now and register later.
If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.
Question
Sbsyncro
I was one of the "early adopters" of the KG1000 and it has been my main radio in my Jeep for about 3 years now. The KG1000G has always had some issues (had to replace one radio early on because of mic gain issues and static/popcorn that would not go away). But the issue have started to become obvious defects and I'm hoping that perhaps a firmware update or something like that might make the radio function properly. The latest two issues are as follows:
1. Normally I run with Channel 15 (with tones) on the A side of the radio and Channel 17 with tones on the B Side (our club uses these are our A and B channels). While on GMRS channel 15 (462.550) or 17 (462.600) on the A-side of the radio (these are the only two tested), there is constant bleed-over from FRS channel 1 (462.5625). Every time some kid on a walkie talkie starts sqwawking (or there is a blast of interference on that frequency like in my video as I was sitting in an In-n-Out drive-through), it breaks the squelch on my radio and stomps over whatever legitimate traffic is on my selected frequency. The display will even briefly indicate "GMRS-01" while the interference is happening. This does NOT happen on the B side of the radio. I have tried adjusting the squelch up and down and it makes no difference. This makes the radio nearly unusable and I have to shut off the A side of the radio and only use the B side.
2. On both the A and B sides of the radio, regardless of what frequency or channel I am using, ALL broadcasts received will "clip" a few seconds into the transmission (drop out so I cannot hear for about 1 to 2 seconds). If I am running an HT right next to the KG1000-G it will NOT exhibit this problem, so I know for certain that the issue is the KG1000 itself. I can reproduce this issue at will by having another radio make a broadcast longer than about 10-15 seconds. I have also tested with my DB20-G and it does not have this problem while running trails with my group.
Do either of these issues sound familiar to anyone, and if so is there a firmware update to address the issue? I don't know what the warranty period is on this radio, but it looks like I'm coming up on the 3 year mark of owning it. (honestly based on my experience with this radio I'm not sure I can continue to recommend it!). Maybe I just got a buggy one but its been problematic throughout its lifetime with me...
Buytwowayradio has always provided great support - I hope there is an easy fix to this issue so I don't have to replace the KG1000 in my main vehicle with my cheapie backup radio (which never has problems!)
11 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.