Wouxun KG-1000G Scanning?

[Mikeebob]

While scanning I would like to continue scanning after the RX transmission ends (so many seconds).

 

Right now it just stops scanning and won't resume scanning.  

 

Any thoughts...?

 

Thanks,

Mikeebob

[Mikeebob]

Well... Looks like I found my own answer! Overlooked it. Uggggg

 

Menu 10

 

TO---Continues afer 5 sec

CO---Continues after 3 sec (signal lost)

SE---Scan stops... Press PPTor funcytion key to store it

[tpp517]

FYI, TO works better for me, CO seemed to resume scanning even though a signal was present.

[scorpion1200]

I love this radio it out performs my MXT400.

Wouxun KG-100G is a winner!!!

I like that you can scan the CTCSS and DCS only when someone transmitting.

The only downside is on VFO mode i can only input frequency range 400.000-479.995MHz.

I thought it would go up to 499.999MHz.The MXT400 range is 400-489.995MHz.

I need the 483.000MHz range.

 

 

 

[serrasalmus]

i love the way the scan groups are setup. i have my a side scanning the standard gmrs channels 1-22 and some 2m and 440 repeaters along with the iss and my local FD, then side b side is scanning only the 5 local gmrs repeaters i use. ive also set up scan groups for when we go wheeling, ive got it set to scan only the gmrs channels to listen to see if anyone needs help. and with the primary channel switch u can always monitor a set channel....so far been a darn tootin good radio

[Sbsyncro]

—-[Moved to another thread]—-